Forums

Hello,

I have recently updated my DM7000 with OpenPli. Everything works fine and I have installed the Rytec XMLTV plugin. I slightly modified the e1_CDS_TVV.sh script to enable the path to my epg.db on the USB drive (I did the same ting on my PliJade3). The updates went fine and the EPG data is correct but when I zap, I see the correct EPG data in the OSD and after a few seconds the EPG data (only in the OSD) is "updated" with old EPG data. This happens also when I press "OK" on the remote control to see the OSDbut then the old EPG data is already there.

This phenomena is not happening on all channels (not on NED1, NED2 and NED3) but on most of them it is. I have configured the EPG als SQL-lite on my USB stick and switched off the MediaHighWay EPG and the Dish EEPG/BEV.

Did I miss a configuration setting to prevent this "update" with old EPG data?

All tips and hints are welcome, thanks in advance..........

Gusman /images/smiley/wink.gif

Every channel broadcasts now/next events. If present they have precedence over EPG information stored. So if they are different, you'll see them change in the OSD.

disable EIT EPG for now/next event if you have this option in image advanced settings.

Wanwizard and Natalka thanks for the information.

@Wanwizard: Does this mean that this "problem" will fixed if the now/next is in sync with the stored EPG data? Is there a way to re-initialize the now/next EPG in the ODS?

@Natalka: I'm not sure if OpenPli has this option "on board" in their image, i have searched for ir but I couldn't find it...........

Regards,

Gusman /images/smiley/wink.gif

It's not a matter of fix.

A channel can have EPG information, and now/next information. If now/next is present, it will be displayed in the OSD infobar instead of the EPG data. It is broadcasted, so it's not under your control.

Wanwizard,

Thanks again for the update. I'll wait until now/next information is in sync again.........

Gusman /images/smiley/wink.gif