Forums

Cannot select NTSC during a remote flash procedure. Can someone specify the keys to hit upon boot up exactly?


Thank you.

can you be more specific?
i dont fully understand your question...

P1x44r wrote:
Cannot select NTSC during a remote flash procedure. Can someone specify the keys to hit upon boot up exactly?


Thank you.

Use the left and right buttons to switch TV system settings.
If the flash was done you can do it in <setup><system Settings><AVV Settings><TV System>

greetings
RuKo

Thanks guys, I have selected it somehow.

What I meant that that I didn't know exactly what buttons to press to switch to NTSC upon the very first boot up after flashing of DM500 with Garnet. Upon flash the system boots up in PAL by default and I can't see much on the screen. I was wondering what was the exact key combination I needed to press to switch over to NTSC without seeing what's going on on my TV screen.

Ok , I think I understand,
first push two times on the down button, than you are in the "TV system select bar".
After that push three times on the right button, than you have selected NTSC system.
Push now on the green button to save the settings.

regards
RuKo

Thanks for help RuKo!