Er zijn 6 reacties in dit onderwerp

[JoMensdorf]

Hi!

 

I just reconfigured my ET9200 with OpelPLI 4.0.

And now I do have a "red touch" in my picture using the YPbPr port,

the HDMI signal works fine. The picture during the boot process is good.

I do have to use this YPbPr for my Slingbox350, it doesn´t have a HDMI port.

 

Tried different cables and almost all settings in the video-section, I also downgraded

back to OpenPLI 3.0 with the same problem.

 

Does anybody have a hint for me?

 

Thanks a lot,

Jo

 

 

 

 

Bijgevoegde Bestanden

•  Red.jpg   31,88K   20 Aantal bijlagen

[JoMensdorf]

Found the solution:

video output: Scart

color format: YPBPR

 

Jo

[Sjaaky]

"a red touch" would be the understatement of the month .

 

As you already found out, this is a mismatch in colorformat. YpBpPr vs RGB.

[JoMensdorf]

I think the resolution is worse know because I´ve chosen SCART.

Is there any chance to get at least 720p without the red color?

It works fine during the startup, so it look like a software bug.

 

Thanks,

jo

[blzr]

if you changed color format for the SCART output, you can switch video output back to YPbPr - picture shouldn't have a 'red touch' now...

Veranderd door blzr, 13 juni 2014 - 11:29

[Rob van der Does]

As internally the Scart & Component output are interconnected, you should for using the Component cinch connectors set:

1- Scart to component

2- YbPr to 1080i etc or whatever you want.

 

So you have to do both.

[JoMensdorf]

As internally the Scart & Component output are interconnected, you should for using the Component cinch connectors set:

1- Scart to component

2- YbPr to 1080i etc or whatever you want.

 

So you have to do both.

Got it, SatKierd and blzr. Thank´s a lot!!!

Now I have a clean picture without any "touch"...

 

Jo

Veranderd door JoMensdorf, 13 juni 2014 - 22:58