I tried installing a different GUI on my Solo pro v2 wich runs enigma 2 and now it won't startup properly and I keep getting this message.
Solo pro V2 crashing after trying to install GUI
Re: Solo pro V2 crashing after trying to install GUI #2
Geplaatst op 9 maart 2017 - 19:47
Looks like a non-compatible skin.
Telnet to the box, immediately after you switched it on. Try until you succeed, and then immediately type the command "init 4". This stops the box from rebooting.
Now edit /etc/enigma2/settings, look for the line "config.skin.primary_skin=", and remove it. After this change, type "init 3" to start Enigma2 again. It should start up with the default skin.
Currently in use: VU+ Duo 4K (2xFBC S2), VU+ Solo 4K (1xFBC S2), uClan Usytm 4K Pro (S2+T2), Octagon SF8008 (S2+T2), Zgemma H9.2H (S2+T2)
Due to my bad health, I will not be very active at times and may be slow to respond. I will not read the forum or PM on a regular basis.
Many answers to your question can be found in our new and improved wiki.
Re: Solo pro V2 crashing after trying to install GUI #3
Also tagged with one or more of these keywords: Crash, Error, GUI
OpenPLi crash Enigma2, signalBegonnen door GreenCoax, 23 apr 2024 crash, 9.0, signal |
|
|||
OPENPLI 9 : CrashBegonnen door Josh8191, 21 apr 2024 Openpli 9, crash |
|
|||
Tempest EPG GeneratorBegonnen door kvanc_tempest, 16 mei 2022 xmltv, epg, php, gui, generator |
|
|||
ProblemsBegonnen door h.beerlage, 1 dec 2021 Crash |
|
|||
|
ProblemsBegonnen door 40H3X, 1 dec 2021 Crash |
|
1 gebruiker(s) lezen dit onderwerp
0 leden, 1 bezoekers, 0 anonieme gebruikers