The photo's prove that this is most likely a setting on your TV... When you have a FULL-HD TV or above you need to reconfigure your TV... And not Enigma2... (Except when you have an extreme old HD-Ready TV with a resolution less than 1920x1080)
i did not change anything for like two years on my tv ...cause i do not have the remote for it:)
and if its my TV , I would change settings on my tv not on this overscan stuff on openpli on every reboot
It happened since 6.2rc , i though it was a buggy thing but no , it is on 6.2 stable too now.
It is really like there is no overscan set ups or even not overscan at all after every reboot.
Edited by blunt, 16 May 2018 - 14:06.