hello . i have a vu+ solo se v2 with openpli 4.1 image . i try to run cccam . but i keep get that error : No parse cannot emu
did you have a solution for that please ???
thank you
No Parse cannot emu cccam problem
Begonnen door: nino2610, 16 sep 2018 13:17
Er zijn 2 reacties in dit onderwerp
Re: No Parse cannot emu cccam problem #2
-
- Senior Member
- 5462 berichten
+114
Excellent
Geplaatst op 16 september 2018 - 13:53
Are you actually trying to get support for a cardless box?!?
CCcam.cfg has to be set up for the card(s) that reside in your cardslot(s). Most cards do not require special settings in CCcam.cfg apart from some Irdeto-2 and all Nagra cards.
The error you are mentioning is normally not shown unless accessing a WLAN location that has no support for your CAID... But please correct me if I am wrong.
CCcam.cfg has to be set up for the card(s) that reside in your cardslot(s). Most cards do not require special settings in CCcam.cfg apart from some Irdeto-2 and all Nagra cards.
The error you are mentioning is normally not shown unless accessing a WLAN location that has no support for your CAID... But please correct me if I am wrong.
Met één been in het graf..... Helaas
Re: No Parse cannot emu cccam problem #3
-
- PLi® Core member
- 68625 berichten
+1739
Excellent
Geplaatst op 16 september 2018 - 14:19
There has never been an "OpenPLi 4.1"? And this smells like a card-sharing issue...
Currently in use: VU+ Duo 4K (2xFBC S2), VU+ Solo 4K (1xFBC S2), uClan Usytm 4K Pro (S2+T2), Octagon SF8008 (S2+T2), Zgemma H9.2H (S2+T2)
Due to my bad health, I will not be very active at times and may be slow to respond. I will not read the forum or PM on a regular basis.
Many answers to your question can be found in our new and improved wiki.
1 gebruiker(s) lezen dit onderwerp
0 leden, 1 bezoekers, 0 anonieme gebruikers
