Zgemma HS w/ openPLI
#1
Posted 25 July 2019 - 13:51
Re: Zgemma HS w/ openPLI #2
Posted 25 July 2019 - 14:07
Hi,
Over-heating problem, your box start get troubles when it became too hot.
Let it cool down and retry again.
You perhaps have a defective capacitor.
Pr2
NO SUPPORT by PM, it is a forum make your question public so everybody can benefit from the question/answer.
If you think that my answer helps you, you can press the up arrow in bottom right of the answer.
Wanna help with OpenPLi Translation? Please read our Wiki Information for translators
Sat: Hotbird 13.0E, Astra 19.2E, Eutelsat5A 5.0W
VU+ Solo 4K: 2*DVB-S2 + 2*DVB-C/T/T2 (used in DVB-C) & Duo 4K: 2*DVB-S2X + DVB-C (FBC)
AB-Com: PULSe 4K 1*DVB-S2X (+ DVB-C/T/T2)
Edision OS Mio 4K: 1*DVB-S2X + 1*DVB-C/T/T2
Re: Zgemma HS w/ openPLI #3
Posted 26 July 2019 - 13:08
HI - I've let it sit a few days actually. I don't think it is overheating - it worked fine for about 2 years until I started using that Droidbox in the other room, it was as if the Enigma plugin on it took control of the motor, if that makes sense?
When streaming to that droidbox, I was unable to use the motor to choose different satellites - the other channels in other satellites were greyed out and I'd get a "tune failed" message.
It is as if when connecting it up to a different motor, with different gps coordinates, it came to life. All the other person did to fix it was rescan for satellites - found them, put in my gps coordinates and sent the box back.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users