Forums

Anyone running snmp on pli 6.1?
I'm trying to achieve the following:

When it's snowing heavily, it sometines builds up on antenna, redusing signal strength below critical level, leading to corrupt recordings.

I'd like to monitor signal strength and trigger an alert if dB value decreases below a set value.
Another value to monitor are free disk space for recordings.

It struck my mind that the best way ro do this was to use an snmp tool to reading off these values every 5 minutes from my good old dreambox 8000.

The sw repository don't have any snmp plugins, at least not on my pli 6.1 installation, however I read somewhere that there should exist a snmp plugin for openpli. So I turn to the experts for advice:)
Many thanks for any advice.

There is an snmpagent plugin in the feeds, which looks like it does what you want (I see BER/AGC/SNR/SNRdB/LOCK values in the OID list). But I've never used it.

I did use it a long time ago, and then it worked flawless. 

Many thanks for replys. Why don't I see the snmp plugin in the feeds? I'm using openpli 6.1 and original dm8000 hw. Please describe what procedure you perform to get it from the feed since I'm a bit clueless why I don't find it. Many thanks

It is available in the 6-release feed:

./mips32el/enigma2-plugin-extensions-snmpagent_2.0+git11+461b207-r0.3_mips32el.ipk

maybe already installed?
 

Finally found it and installed it, many thanks!