Problem with Wi-Fi
vit
26 Jan 2021
Hi all, my new "Vu + Duo 4K se" with OpenPli 8.0 image has a problem with Wi-Fi.
This works without problems until I do a full system reboot; When restarting, in order to reuse the Wi-Fi I must necessarily deactivate the wireless card and reactivate it otherwise it does not connect to the router.
P.S. it is curious to see in the attached image that the "connection quality" and "signal level" data are missing.
Some advice??
Thanks
Attached Files
-
rete.jpg 24.56KB
4 downloads
WanWizard
27 Jan 2021
P.S. it is curious to see in the attached image that the "connection quality" and "signal level" data are missing.
This is a bug or omission in the driver, it simply doesn't provide these values. I've looked for ways around it, but the data simply isn't there.
vit
27 Jan 2021
Good morning,
hemm ... I have set the network card with static IP address but the problem persists;
Not a big deal I hope I don't have hardware problems.
Greetings
WanWizard
27 Jan 2021
I don't know why it doesn't automatically connect. I don't have an SE and no Fritzbox test, in my setup (Duo 4K and Draytek) I don't have this issue.
Trial
27 Jan 2021
Hi,
in my Network I have network problems with my boxes and IPV6. I think my problem is connected to my PiHole. Try disable IPV6.
Ralf
WanWizard
27 Jan 2021
Same drivers, same issue. The "iw" commandline tools don't provide the information either.
