Looks like driver issue.
Did you try another firmware?
OS MIO+ 4K - no framebuffer available
Started by Stan, 23 Sep 2024 11:02
24 replies to this topic
Re: OS MIO+ 4K - no framebuffer available #21
-
- Senior Member
- 449 posts
+8
Neutral
Posted 25 September 2024 - 11:03
607xRAYHTECV13
ET4x00RAYHTEC4.0
XP1000RAYHTEC7B
H9COMBORAYHTEC9b
Re: OS MIO+ 4K - no framebuffer available #22
-
- Senior Member
- 392 posts
+15
Neutral
Posted 25 September 2024 - 12:35
@el bandido
That pinout can not be right. "Ground" is on Ring 2 and only on Ring 2 (assuming Ring 2 is the one near Sleeve).
I'll have to try now which is TX and which RX.
If my pinout is wrong, then what is the Correct pinout?
Thanks.
Re: OS MIO+ 4K - no framebuffer available #23
-
- PLi® Core member
- 70,365 posts
+1,807
Excellent
Posted 25 September 2024 - 12:44
Looks like driver issue.
Did you try another firmware?
I already mentioned that. Corruption was ruled out by the TS by flashing a newly downloaded image.
The drivers are from 20211103, so other firmware will have the same drivers, unless it is very old.
Currently in use: VU+ Duo 4K (2xFBC S2), VU+ Solo 4K (1xFBC S2), uClan Usytm 4K Ultimate (S2+T2), Octagon SF8008 (S2+T2), Zgemma H9.2H (S2+T2)
Due to my bad health, I will not be very active at times and may be slow to respond. I will not read the forum or PM on a regular basis.
Many answers to your question can be found in our new and improved wiki.
Re: OS MIO+ 4K - no framebuffer available #24
-
- Senior Member
- 449 posts
+8
Neutral
Posted 25 September 2024 - 13:17
I noticed the dvb modules for Osmio4kplus in Open Alliance are dated 20211228.
607xRAYHTECV13
ET4x00RAYHTEC4.0
XP1000RAYHTEC7B
H9COMBORAYHTEC9b
Re: OS MIO+ 4K - no framebuffer available #25
-
- Senior Member
- 377 posts
0
Neutral
Posted 25 September 2024 - 16:15
@el bandido
Your pinout is correct. I was using the wrong plug (14mm instead of 17mm lenght), and therefore the contacts were misaligned.
3 user(s) are reading this topic
0 members, 3 guests, 0 anonymous users
