Jump to content


Photo

How to scan a SAT>IP virtual tuner

Started by pharmswo, Yesterday, 16:59

  • Please log in to reply
2 replies to this topic

#1 pharmswo

  • New Member
  • 2 posts

0
Neutral

Posted Yesterday, 16:59

Hi,

 

I have a vu+ duo2 running openpli 9.1 (flashed today 27.12.2024)

the vu+ is not connected to any Satellite cable (4 tuners all disabled). I'm trying to connect it to my Sat>IP server a Kathrein EXIP 418 (which works with tvheadend, kodi etc)

 

After the new flash I have installed the satipclient plugin.

 

In the sat>ip client menu I have added the sat>ip server successfully

 

Now I also get a 5th Tuner "Tuner E: SAT>IP DVB-S2 VTUNER (DVB-S2)

 

I cannot figure out how to scan this tuner and so get the channels....

 

Can anyone help me with the next steps....

 

Regards

 

Paul


Re: How to scan a SAT>IP virtual tuner #2 pharmswo

  • New Member
  • 2 posts

0
Neutral

Posted Yesterday, 17:39

And two more minutes go by and I have fixed it.

The tuner needed to be set up as simple, single, with the sat 28.2 and send DiSEqC off


Re: How to scan a SAT>IP virtual tuner #3 WanWizard

  • PLi® Core member
  • 70,949 posts

+1,835
Excellent

Posted Yesterday, 17:49

Thanks for the feedback.

 

I assume the config of the tuner must match that of the SAT>IP server tuner that is exported?


Currently in use: VU+ Duo 4K (2xFBC S2), VU+ Solo 4K (1xFBC S2), uClan Usytm 4K Ultimate (S2+T2), Octagon SF8008 (S2+T2), Zgemma H9.2H (S2+T2)

Due to my bad health, I will not be very active at times and may be slow to respond. I will not read the forum or PM on a regular basis.

Many answers to your question can be found in our new and improved wiki.

Back to [EN] Enduser support

1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users

  1. Forums
  2. → PLi® Support
  3. → [EN] Enduser support