6 replies to this topic

[jaymandk]

hi all.....

nice forum here, very cool :-)

well i have this problem... i have a dm 7020 with newest pli image installed
but it can not read my new nds card, so i have bourght me a smargo card read, and it setup to autoswitch and dreambox, with the windows software.
my problem is that i can not get the dreambnox to read the card from it, i read some place that you need to enable usb in kernel settings ???? or is this not right ???
i did add the
SERIAL READER : /dev/usb/tts/0 smartreader+
to cccam.cgf line..

any suggtions...
thanx in advance for helping me out...

best regards jaymandk

[spock]

try in console: opkg install kernel-module-ftdi-sio

and reboot.

also try changing this: /dev/usb/tts/0
to this: /dev/ttyUSB0

Edited by spock, 13 March 2012 - 22:46.

[jaymandk]

dont fully understand what you mean ???? dosent somebody have a solution for this problem ???

best regards jaymandk

[pieterg]

wasn't 'dreambox mode' only for the powerpc dreamboxes?
Try with normal mode instead.

[razorback]

set the smargo to "Normal" instead of "Dreambox"
as pieterg mentioned this dreambox mode was necessary some time ago (not only for powerpc but also for DM-800 with early Gemini Images).

and then - as Spock mentioned - change the line in cccam.cfg to
SERIAL READER: /dev/ttyUSB0 smartreader+

and everything should be working ok.

R

[jaymandk]

i did that, but when i check in ccam info, it says no crad inserted in dev/usb ???
very strange....
do i need to install any kind of drivers or activate the usb in somehow ?

best regards jaymandk

[pieterg]

no crad inserted in dev/usb

/dev/usb is not a correct device node