3 replies to this topic

[Halling51]

Hi.
Have installed OpenPLi 3.0 on Vu+ DUO and I can not see the programs anymore! The only on is CNN Int. Is there any that could give me a clue? I have followed the infogiven by many on the forum but still I am struggling with the channels. Would apreciate any good advice. At the moment I am using mgcam Have CCcam221 and also 2.3 installed. It seems I am in lack of the softkamk#¤s!?

Thanks in advance
Norweger

[pieterg]

go to the satconfig, and correct your tuner settings.

A:19.2
B:13.0

will have changed to

A: auto
B: auto

[Halling51]

I have tried todo that but it does not help as the antenna do not move! OpenPLi3.0 is stable and I have got less problems with it then others.I will try to make the enderungen again. If not I have to move to another not so komplicated. It is essential that the antenna is moving from 19.2 to 13. I am not sure either if the Hotbird is there as the satfinder does not find it as I have no channels to view. Only CNN on 19.2.
Reinstall?

Thanks for your reply
Norweger

[popeye2]

For dmm800SE also diseqc seems to have some errors. Automatic scanning does not work, only manual scanning does..
Although diseqc is set to always, , the 14/18/22 does not work properly (You need a Spaun TP208 diseqc monitor or similar)