8 replies to this topic

[DrAk3]

Hi all,
after the last upgrade sometimes the audio doesn't work in ac3 channels. There are 2 way to solve the problem:

- switch audio channel with the yellow button
- zap into another channel and than come back

i can reproduce the problem switching from an sd channel (with audio stereo) to an HD with ac3 audio.

Is someone need some e2 log ask

D.

[pieterg]

which channels are affected? (so we can reproduce the issue)

[mblum11]

Hello,

look for some channel with MPEG audio , then switch to some channel mit AC3 audio -> no sound

Edited by mblum11, 6 November 2012 - 19:20.

[littlesat]

E.g. when you zap from SBS6 to RTL5 then you have no sound... then from RTL5 to RTL4 the sound returns and then back to RTL5 you have sound.
When switching from mpeg to AC-3 no sound... from AC-3 to another AC-3 sound returns....

[DrAk3]

in italy you can reproduce the problem switching between Canale5 and italia1 HD (which have the ac3 audio track).

if you have skyit switch from fox +1 and fox HD

D.

Edited by DrAk3, 6 November 2012 - 19:38.

[jedeje]

Also reported here: http://openpli.org/f...-and-ac3-sound/ and here: http://openpli.org/f...io-nach-update/ .

Any zap from a PCM audio channel to an AC3 audio channel triggers the behavior.

Regards,
jedeje

[hemertje]

update & try again

[DrAk3]

good job! after the update all is ok! :D

ty!

D.

[guirigui]

Same AC3 issue with ET6000 fixed this morning...congratulations to Open PLI team.....