14 replies to this topic

[ovidijuslr]

Hello everybody,question is,after fresh image flash on vu+solo2 with latest openpli how to load personal settings from backup?
Thanks for answers

[mattiL]

If you use Autobackup there is very little you need to do, the backup is automatically restored after re-flashing the receiver.

[ovidijuslr]

Thank yes i have backup done so judt stick usb in after flash and whats next?

[mattiL]

Just flash and follow the directions (remove stick and reboot).

[ovidijuslr]

Ok its done where backup files should be on internal hdd or should I put in usb stick?
Thank you

[mattiL]

Internal HDD, I think that is the default for Autobackup.

[metoo]

have you also enabled autoinstall inside autobackup ?

autobackup can be on usb or internel hdd

[ovidijuslr]

Thanks for replying no I did not enabled auto install in autobackup where I can enable that? Sorry for silly questions im on a learning road

[ovidijuslr]

Thanks for replying no I did not enabled auto install in autobackup where I can enable that? Sorry for silly questions im on a learning road

[metoo]

in the menu from autobackup plugin 

[mattiL]

I re-flashed my receiver today and did not enable 'Create Autoinstall', it is not needed for reflashing if you have the backup on the internal HDD.

In fact, I have re-flashed many times and never used 'Create Autoinstall'.

[metoo]

autoinstall downloads and installs the plugins your where using new from feed.

autobackup  your usersettings

Edited by metoo, 12 December 2014 - 18:43.

[ovidijuslr]

Thanks for answers so I will do backup in to internal hdd, flash new openpli and install autobackup plugin from feeds, after go in autobackup and restore my settings?

[metoo]

normally it goes fully automatic directly after flash, there is no need to do aything.

just before flash activate autobackup, autoinstall and make manual (yellow button) backup to internel hdd or usb

[ovidijuslr]

Ok thanks to everybody