3 replies to this topic

[Rock69]

Hi

 

First post, please go easy on me. I did a search but didn't find anything relating to this issue.

 

I've gone from pli 3 to pli 4.0, if I leave the box in standby I can see the REC red light come on and when I bring the box out of standby I get the No Free Tuner! message.

 

Its only happened since the move from version 3 to version 4.0 and its fully updated, as of yesterday.

 

If I reboot the box and select a channel and leave it on it doesn't happen, its only if I put it in standby or I do something in the menu that stops the channel from displaying.

 

All channels on all satellite lists go grey and I'm unable to select any of them without getting No Free Tuner popping up.

 

The OpenWeb interface has been disabled, I thought perhaps something else was trying to take control of the box and there are no timer recordings setup

 

Any advise or help much appreciated.

 

Eddie

[Erik Slagter]

1. What kind of LNB's do you have (how many outputs do they have)

2. How many of these are connected to the receiver by INDIVIDUAL cables

3. Does each tuner have it's own cable to the LNB

4. How did you configure the tuners; "loop through" is incorrect, use "same as".

5. Is your network secure, are you sure nobody from the internet is streaming from your receiver

 

These are the most common causes of this error.

[Rock69]

Thanks for the reply.

 

I have 1 single LNB via one coax cable to connection A - there is nothing in B and its set to a Simple satellite configuration using USALS 

 

There is definitely no one connecting remotely via the internet, i've even unplugged the cable to be sure.

[Erik Slagter]

Restart enigma when this happens. Sometimes recordings can hang around.