644 replies to this topic

[WanWizard]

Outgoing? Yes, any box that can transcode. 

 

Or do you want to transcode in incoming IPTV stream? Then the answer is no, it is an STB, not a broadcast station.

[lordgothic]

hi, everybody in this great forum

i have a vu+ solo 4k and im reading all this post about tbs5925

i have some questions... may some can help...

im interest in buy a tbs5925 for get multistream channels at 4.8e, 12.5w and specially 30w (because i live in canary islands) and also for makes satellite blindscan for sr low channels

my question its that vu solo 4k finally support tbs5925 with openpli and i can watch multistream channels with tbs5925

thank you soo much for your time

Edited by lordgothic, 7 November 2017 - 15:10.

[manski]

Hi everybody , I bought VU uno4k SE with OPENPLI , works OK , but .... Before i use VU solo2 , there was two video output signal , HDMI with parameters set in menu ( i used 1080p , this signal was connected to my main TV ) , and second video output SCART ( there still was signal 561i independent of menu settings , and i connected this signal to analog RF TV modulator , and transmit in my home network to the others TVs ) Now in VU uno 4k SE is only one video output as HDMI , this output works ok , i used 2160p to main TV , but i have not other output to the rest of TVs . How to split video signal to use one output to main TV , and second output to other TVs , i tried use of HDMI splitter , but device as tested not works with signal 2160p@60Hz , also i don't need 4k signal on both outputs . Also when main TV is off ( sony android TV ) this TV sometimes wake up , for a seconds , and this cause video signal lost for 1-2 seconds on second HDMI output . I have idea connect USB Video adapter ( USB3.0 to HDMI , the better was USB3.0 to SCART , but doesn't exist ) set output resolution to 720p ( this is enought for other TVs ) , but this need driver to second one video card , and create settings to clone video output from main HDMI to second HDMI , is that chance to work , which type of  USB to HDMI adapter will be support by OPENPLI software .

[Trial]

Hi,

USB3 for Video output will not work because of missing driver. HDMI splitter with downscaling is not a simple splitter anymore it is a scaler and more or less expensive. I would say buy a simple Android streaming box and stream you video transcoded through ethernet.

 

ciao

[manski]

I can buy cheap USB 3.0 Video output adapter ,this adapter has a linux ( ubuntu ) driver  ( https://github.com/FrescoLogic/FL2000 ) , but this is driver for PC architecture , is it possible to compile this driver for VU uno4k SE architecture ?

I'm not programers , only power electronics specialist .