5 replies to this topic

[RAMSES]

Greetings and wish you a happy new year. With the new year, a new image .. at least as I had an idea ... Unfortunately I did wrong. STB. Vu + Ultimo, DiSEqC EMP Centauri http://www.emp-centa...=prodview&id=82, parabola 85 Fe multibeem  I installed the latest image OpenATV. After installation it was not vobec configure the tuner for STB. Not for one position is not found at all signal from the dish. Then I went back image OPEN pli. Tuner OK, tuned all six LNB. Unfortunately that's not quite "koušer" to change the tune or do not even know one station in position 0.8W, 11823/30000. I put the receiver to a new satelites.xml, I put the automatic updating of all transponders tuned, I have a factory setting and once autumatickú update, but unfortunately does not help. Stb. displays a message [u] "no data on the transponder (expired time lines read PAT)" [/ u] Maybe it's just an ordinary schoolgirl error on my part .. The fact is that "riddle"

 

Maybe I forgot to mention quite a significant thing. On the lower frequencies above 11 823/30000, 0,8W for the EPG stations but the picture and sound are no longer .

This issue has emerged as a new image in the openATV and also with openpli .. I think that there probably forgotten about developers fix the image to be compatible with the driver for that model VU + ..

 

I would ask developers to comment on the above mentioned problem ..
Well thank you

Edited by RAMSES, 10 January 2016 - 13:00.

[RAMSES]

For clarification. This is a TP 11823 H, TP 6, K2, DVB-S2,8PSK, SR 30000 FEC 5/6

[RAMSES]

So how ?,. no one has a solution ??

[WanWizard]

Not sure how many people have 0.8W here.

 

In general, it is a bad idea to replace the satellite.xml that comes with an OpenPLi image. The one we supply is up to date, and is updated every Friday. Other sources might have differences in the XML, causing a mismatch between the XML definition and your channel list, which in turn can cause problems with reception.

 

Flash OpenPLi again, do not restore a backup, configure your tuners, and manually scan TP 11823 H, while making sure the parameters are OK.

[beastyboy]

I am also using the latest OpenPli image with my vu+ solo2 + one Spaun diseqc and i have no problems with 11823.00 H BSS06 K2 Europe DVB-S2 8PSK 30000 5/6. Mayme there is something wrong with your diseq switch. If you connect only your 0,8 W lnb directly to your ultimo (excluding the diseq switch) can you tune that frequency?

[zeros]

No problems here (I tried out). Maybe VU+Ultimo drivers? (SR 30000)

Edited by zeros, 21 January 2016 - 18:34.