4 replies to this topic

[SpliNT]

Hello, i'm losing my mind a little bit over this so some feedback would be awesome.

 

My setup looks like this:
Dish with 2x Quad LNB which are set in fixed positions to two different satellites.
Quad LNB 1: Thor 0.8W
Quad LNB 2: Astra 4.8E

Vu+Duo2 with Open Pli 4 (OpenPLi-4.0-beta-vuduo2-20160701)
Twin tuner (S2) 1 (A + B ) = 2 cables from LNB 1
Twin tuner (S2) 2 (C+D) = 2 cables from LNB 2

Tuner config looks like this:

 

I have backuped bouquets I'm using.

I've done a manual scan on Tuner A for Thor 0.8W and afterwards a manual scan for Tuner C for Astra 4.8E.

Directly after scanning Tuner C (Astra 4.8E) it looks like this:

 

 

As you see here, tuner C works and D immediately become unusable.

When I change channel to Tuner A (Thor 0.8W) C & D immediately become unsuable,
as if they're being used.

 

 

Switching back to the previous channel on LNB2 Astra (4.8E) gives me

 

 

I've tried moving the cables from LNB 2 to Twin Tuner 1 and LNB 1 to Twin Tuner 2

and I got the same results but the opposite, causing A & B to become unusable while C & D on work.

 

I also tried changing one the twin tuners with a brand new one, same thing.

No luck with OpenVix or Blackhole, different versions of softcams.

This used to work fine between 2014 (when I bought it) and 2015.
I'm wondering if it could be bad drivers maybe?

What are your thoughts on this? Any ideas are appreaciated.

Thanks in advance.

Edited by SpliNT, 9 July 2016 - 16:25.

[janejak]

Have u checked u downt have on timeshift?

[WanWizard]

Box open on the internet, and now being used in an IPTV share? You can check for active streams via menu - information.

[SpliNT]

Ah hell.. seems like I've had an german intruder all along. Put on http auth for streaming and now he's gone. Can't believe I didn't think of it.... 

Is there any banlist in openpli for excluding ip's?

 

Changing streamingport as well, thanks for the tip WanWizard. This has been a headache for months..

Edited by SpliNT, 9 July 2016 - 22:05.

[WanWizard]

Nope.

 

NEVER open your box onto the internet. It is not a security device, and it is not designed to be a secure device (everything runs with root access). Changing the port will probably buy you hours, or only minutes. It doesn't solve anything.

 

Make sure your box is behind a NAT router or (preferred) a firewall, and use a VPN to access it.