Posted 30 November 2016 - 02:21
Hi there
i am new to all this and i was wondering how i can get the signal agc and ber back on the main infobar at the bottom right hand side of the screen
Where in the skin.xml would i do this. I am using PLi-FullHD skin
Any help or advice would be greatly appreciated
Thanking you in advance
Edited by muzzy, 30 November 2016 - 02:22.
Posted 2 December 2016 - 14:32
Hi,
Enable the second infobar in OpenPLi and you will have the SNR/AGC/BER there, so you can check what is done in the second infobar to port it into the first infobar.
Pr2
NO SUPPORT by PM, it is a forum make your question public so everybody can benefit from the question/answer.
If you think that my answer helps you, you can press the up arrow in bottom right of the answer.
Wanna help with OpenPLi Translation? Please read our Wiki Information for translators
Sat: Hotbird 13.0E, Astra 19.2E, Eutelsat5A 5.0W
VU+ Solo 4K: 2*DVB-S2 + 2*DVB-C/T/T2 (used in DVB-C) & Duo 4K: 2*DVB-S2X + DVB-C (FBC)
AB-Com: PULSe 4K 1*DVB-S2X (+ DVB-C/T/T2)
Edision OS Mio 4K: 1*DVB-S2X + 1*DVB-C/T/T2
Posted 3 December 2016 - 19:18
Hi there
i am new to all this and i was wondering how i can get the signal agc and ber back on the main infobar at the bottom right hand side of the screen
Where in the skin.xml would i do this. I am using PLi-FullHD skin
Any help or advice would be greatly appreciated
Thanking you in advance
Open secondInfobar press OK and hold for 2 seconds, then release. Nothing happens then again.
Edited by Loui (PD1LOI), 3 December 2016 - 19:20.
0 members, 0 guests, 0 anonymous users
