in the last week i update daily and time is correct
from yesterday again the time is not correct
why
time in not correct
Started by abumarya, 17 Feb 2017 19:41
4 replies to this topic
Re: time in not correct #2
-
- PLi® Core member
- 70,889 posts
+1,833
Excellent
Posted 17 February 2017 - 19:50
The box gets the time from the startup transponder. If you don't have a startup channel defined, it will use the last used channel.
Not every transponder uses the correct time, so if you have this problem, select a known good transponder, set a channel from that transponder as startup channel (channel list, menu button), then set the box in deep standby, unplug the power, wait a few minutes to make sure the internal clock of the box has lost power, then connect and power up the box again.
Currently in use: VU+ Duo 4K (2xFBC S2), VU+ Solo 4K (1xFBC S2), uClan Usytm 4K Ultimate (S2+T2), Octagon SF8008 (S2+T2), Zgemma H9.2H (S2+T2)
Due to my bad health, I will not be very active at times and may be slow to respond. I will not read the forum or PM on a regular basis.
Many answers to your question can be found in our new and improved wiki.
Re: time in not correct #3
-
- Senior Member
- 64 posts
0
Neutral
Posted 18 February 2017 - 19:27
same start up channel no change
Re: time in not correct #4
-
- PLi® Core member
- 70,889 posts
+1,833
Excellent
Posted 19 February 2017 - 15:03
Pick one that works then, and follow my procedure to the letter. As long as the box has power (or the capacitors are charged) the internal clock keeps running.
Currently in use: VU+ Duo 4K (2xFBC S2), VU+ Solo 4K (1xFBC S2), uClan Usytm 4K Ultimate (S2+T2), Octagon SF8008 (S2+T2), Zgemma H9.2H (S2+T2)
Due to my bad health, I will not be very active at times and may be slow to respond. I will not read the forum or PM on a regular basis.
Many answers to your question can be found in our new and improved wiki.
Re: time in not correct #5
-
- Member
- 9 posts
0
Neutral
Posted 20 February 2017 - 18:42
I have installed ntpd and sync time with the help of NTP.
run
opkg update
opkg install ntp ntp-bin
And configure /etc/ntp.conf
https://forums.openp...ng-time-via-ntp/
2 user(s) are reading this topic
0 members, 2 guests, 0 anonymous users
