Hi Dimitrij;
about that from an other thread;
No one has ever tested OpenMultiboot for Mutant HD 2400.
I think that it will not work, since my requests have not been accepted, more than once.
[all box] add kernel/rootfs value, enable nadsim/ch341 module
first the problem with openmultiboot for vu ultimo 4k and also mutant hd 2400 is i think the same.
i can use openmultiboot with this boxes, but only if i install openpli (similar if pli-4.0 or pli-rc 6) in the flash - then it works perfectly.
the problem which i have seen comes only if i install openpli with openmultiboot on usb-stick
, in this case i have big problems with mounts, i use only fstab with uuid mounts for my harddisc(s) and usb-sticks
so this mounts are 100 % correct but only when openpli was installed in flash
, if i install it on usb-stick then this mounts are didn't work correct despite uuid entries in fstab
in this case two mounts from my four mounts didn't work, and if i look with the command mount in telnet what is fact
mount says all is ok mountet, but be sure, it isn't
regards
Biki3
Edited by Biki3, 25 July 2017 - 19:48.