3 replies to this topic

[monteros_007]

Hello,

 

I'm new guy on this forum. For a few months I've been using a Formuler 3 with openPLI. The software its awesome. My problem is with stream from my decoder to for example my computer. I downloaded m3u list with my bucket and import to VLC. When my decoder its turn on and channel for example is Cartoon Network in VLC player I need switch other channel but only within this transpoder. When I try switch to another channel from another transpoder VLC dont turn channel. I must switch manually to anothter channel by webif. This is normal sytuation? 

 

My parameteres:

Formuler 3

Procesor: Broadcom 7362

Memory: 224856 kB free / 312932 kB total

Software:

Version OE: PLi-OE

Software version: OpenPLi 4 (2017-10-08-release-4)

Kernel version / Data  driver: 4.7.6 / 4.7.6+20161005-r0.5

 

Best Regards

[WanWizard]

If you have a tuner spare, you can watch and stream at the same time, without any need to change the channel on the box.

If you don't, the box needs to be tuned into the same transponder than the channel you want to stream.

If not, the box needs to zap. It will not do this automatically, like it will do when a recording starts.

[monteros_007]

In short, this is normal? Having one decoder and one signal will not work differently?

Edited by monteros_007, 27 November 2017 - 14:40.

[Pr2]

You need to set you box in standby (and enable zap before stream in OpenWebif) if you want to be able to zap from VLC, since you have only one tuner on your box and if it is  turned ON then you can only stream a channel from the same transponder. If the box is on standby then normally you should be able to zap and stream.