Good morning, I have a problem on a vu + only if. during operation I keep loading the wheel on the top left and always blocks the decoder. is it possible to reinstall the original vu + image and then make a clean flash of open pli 6.1?
Thanks for support
6.1 continues to load the wheel and blocks the decoder vu+ se
Started by rubygno, 05 Feb 2018 10:03
3 replies to this topic
#1
-
- Member
- 7 posts
0
Neutral
Posted 5 February 2018 - 10:03
Re: 6.1 continues to load the wheel and blocks the decoder vu+ se #2
-
- PLi® Core member
- 57,168 posts
+698
Excellent
Posted 5 February 2018 - 10:15
You also can try to perform a clean flash with openpli...
WaveFrontier 28.2E | 23.5E | 19.2E | 16E | 13E | 10/9E | 7E | 5E | 1W | 4/5W | 15W
Re: 6.1 continues to load the wheel and blocks the decoder vu+ se #3
-
- Member
- 7 posts
0
Neutral
Posted 5 February 2018 - 11:42
Already done but always the same problem. now I have installed another image and runs well. I think it's a problem of openpli 6.1. thank you
Re: 6.1 continues to load the wheel and blocks the decoder vu+ se #4
-
- PLi® Core member
- 70,528 posts
+1,811
Excellent
Posted 5 February 2018 - 12:03
If with "loading the wheel" you mean the spinner in the top-left corner, it means that Enigma runs fine, but something has blocked the mainloop.
Usually, this is either a plugin that runs for much too long and claims the CPU, or something is waiting for an external event to finish (for example a mount to complete).
Did you flash and restore a backup, of was it a clean flash, with manual configuration, and without installing any plugins?
Currently in use: VU+ Duo 4K (2xFBC S2), VU+ Solo 4K (1xFBC S2), uClan Usytm 4K Ultimate (S2+T2), Octagon SF8008 (S2+T2), Zgemma H9.2H (S2+T2)
Due to my bad health, I will not be very active at times and may be slow to respond. I will not read the forum or PM on a regular basis.
Many answers to your question can be found in our new and improved wiki.
2 user(s) are reading this topic
0 members, 2 guests, 0 anonymous users
