Jump to content


Photo

Motor not moving


  • Please log in to reply
2 replies to this topic

#1 nullb

  • Member
  • 10 posts

0
Neutral

Posted 2 May 2018 - 15:32

Vu+ Solo SE v2 with a Moteck SG2100 in USALS mode.

 

Vu+ tunes channels fine but it wont move the dish at all, tried position setup screen to make it move east and west didn't work either hit the EPG button can see it's sending commands but it's not working.

 

There's nothing wrong with my motor connected to by TBS card and EBSPro it moves fine.

 

Was on the latest stable didn't work factory reset and went to the latest RC doesn't work either, any ideas?



Re: Motor not moving #2 UnimatriX

  • Senior Member
  • 115 posts

+5
Neutral

Posted 13 May 2018 - 21:40

Zojuist van 6.1 (7-5-2018) naar 6.2 (13-5-2018) met Vu+ Solo2. Ook een SG2100 rotor, met usals en unicable lnb werkt op 6.1 wel, draait niet meer op 6.2.
Met backupsuite weer terug naar 6.1 voor nu.

Berichten zijn al wat ouder hierboven. Al bekend wat issue/oplossing is?


Same here. Worked, and works fine on 6.1 (7-5-2018)
Dish won’t move when using 6.2 (13-5-2018)

Re: Motor not moving #3 littlesat

  • PLi® Core member
  • 44,908 posts

+455
Excellent

Posted 14 May 2018 - 13:39

FYI https://github.com/O...0820b7522f33f81


WaveFrontier 28.2E | 23.5E | 19.2E | 16E | 13E | 10/9E | 7E | 5E | 1W | 4/5W | 15W Thanks to Henksat




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users