OpenPLI 6.2 - Vu Duo2 - Diseq not working...
Blaster 18 May 2018
Hi. After upgrading to OpenPLI 6.2, the Duo2 does not communicate with the Spaun 4:1 diseq at all. It's totally gone. Seems like it's not giving power to the diseq. Error shows "nothing is connected". Even it is and nothing is changed other than upgrading to 6.2. It was working fine just until the upgrading where done. Do I have to do a fresh 6.2 install? Or is it any other solution I can try? Or may this be a bug in 6.2? I have tested with new transponder list and reset diseqsettings in enigma2/settings. But nothing helps...
WanWizard 18 May 2018
Your tuner configuration ok? Could you post a screenshot of your tuner config (use the web interface of the box to grab one)?
Blaster 19 May 2018
WanWizard 19 May 2018
Same setting as I have here, but with a different switch. And no problems.
Blaster 19 May 2018
Hmm wierd. Are you using latest 6.2 too? I'll investige further. But it's so strange it happend right after upgrade if it's something else, but I'm going to check everything here.
WanWizard 19 May 2018
My regular boxes all run develop (we eat our own dogfood ).
But I have tested a few (XP1000, VU+ Duo2, Galaxy 4K) with 6.2-release today.
Pr2 19 May 2018
Can you please confirm that you can get signal from the satellite defined on tuner A?
From my own experience, a DiseqC that doesn't commute simply means that there is a shortcut in the cable between the STB and the switch, carefully check your F connectors ensure that there is no shortcut when you install them.
Taykun345 20 May 2018
Sometimes switch just "dies", has happened to me many times, 1x Spaun and especially EMP (2x). EMP ones are prone to breaking apparently??
Aliraza63 21 May 2018
after updating 6.1 to 6.2
my boxes
Duo2
Uno 4k Se
Solo 4k
working fine no issue at all @ 8 Pin diseq
Did u try Opkg upgrade via telnet ?
Blaster 23 May 2018
after updating 6.1 to 6.2
my boxes
Duo2
Uno 4k Se
Solo 4k
working fine no issue at all @ 8 Pin diseq
Did u try Opkg upgrade via telnet ?
Yes, tested already + a lots of other things. I have finally found the problem now. It was actually the Spaun diseqc! Only a half years old. Unbelievable. So new that I did not suspect it at first. Running without it know, and everything works perfect and more smooth. Replacement diseqc on it's way. Hope it will work longer than this. Wierd case. Has Spaun became crap? Or just me very unlucky getting a bad one, bad batch or something? Anyone experience?