As I said, its only one relevant line: (dmesg)
[ 11.604000] __clk_enable: network [1]
[ 11.604000] __clk_enable: enet [1]
[ 11.604000] bcm40nm_pm_genet_enable 00
[ 11.728000] bcmgenet bcmgenet.0: configuring instance for external RGMII (TX delay)
[ 12.898000] bcmgenet bcmgenet.0 eth0: Link is Down
[ 15.085000] bcmgenet bcmgenet.0 eth0: Link is Up - 100Mbps/Full - flow control rx/tx
[ 18.241000] NET: Registered protocol family 10
[ 18.247000] Segment Routing with IPv6
[ 4622.322000] usb 4-1: new high-speed USB device number 2 using ehci-brcm
/var/log/messages:
Jun 10 13:33:44 formuler1 authpriv.warn dropbear[20814]: lastlog_openseek: /var/log/lastlog is not a file or directory!
Jun 10 13:34:06 formuler1 user.info kernel: [ 4622.322000] usb 4-1: new high-speed USB device number 2 using ehci-brcm
--- lsusb
Bus 004 Device 002: ID 174c:55aa
The same device under ubuntu on a usb3 port:
usb 9-1: new SuperSpeed USB device number 2 using xhci_hcd
usb 9-1: New USB device found, idVendor=174c, idProduct=55aa
usb 9-1: New USB device strings: Mfr=2, Product=3, SerialNumber=1
usb 9-1: Product: USB3-SATA-Device
usb 9-1: Manufacturer: ASMedia
usb 9-1: SerialNumber: 20150324000D7D
scsi host9: uas
scsi 9:0:0:0: Direct-Access HGST HTS 541010A9E680 0 PQ: 0 ANSI: 6
sd 9:0:0:0: Attached scsi generic sg8 type 0
sd 9:0:0:0: [sdh] 1953525168 512-byte logical blocks: (1.00 TB/932 GiB)
sd 9:0:0:0: [sdh] 4096-byte physical blocks
sd 9:0:0:0: [sdh] Write Protect is off
sd 9:0:0:0: [sdh] Mode Sense: 43 00 00 00
sd 9:0:0:0: [sdh] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
and thats the lsusb entry:
Bus 002 Device 016: ID 174c:55aa ASMedia Technology Inc. ASM1051E SATA 6Gb/s bridge, ASM1053E SATA 6Gb/s bridge, ASM1153 SATA 3Gb/s bridge