Posted 14 June 2018 - 07:51
Hi
Can anyone confirm that this HDD can be used in my VU+ Duo2?
HDD: Seagate Ironwolf 8TB 3.5'' NAS HDD SATA 6.0Gb/s, 7200RPM, 256MB cache
What I am specifict thinking of, is that is no problem of the size. Physical AND storage capasity.
Can anyone confirm that this HDD can be used in my VU+ Duo2?
Posted 14 June 2018 - 10:05
Any information about max size of HDD in VU+ Duo2?
Posted 14 June 2018 - 10:41
No experience with that disk, but I don't see why it wouldn't work, it is a standard SATA disk.
Having said that, it's a NAS disk, running at 7200rpm, so it isn't the quietest disks. It might run hot as well. And it is designed for allways on, not for the start/stop behaviour of disks in the STB. So personally I would not do this if I needed this amount of storage, but get a NAS instead.
Currently in use: VU+ Duo 4K (2xFBC S2), VU+ Solo 4K (1xFBC S2), uClan Usytm 4K Ultimate (S2+T2), Octagon SF8008 (S2+T2), Zgemma H9.2H (S2+T2)
Due to my bad health, I will not be very active at times and may be slow to respond. I will not read the forum or PM on a regular basis.
Many answers to your question can be found in our new and improved wiki.
Posted 14 June 2018 - 11:05
Thanks for advice.
I was thinking about the 7200 rpm disk was better if I got lots of recordings simultaneously. Will a 5400 rpm disk be good enough?
So an 8 TB HDD will not be a problem?
Edited by Amatøren, 14 June 2018 - 11:05.
Posted 14 June 2018 - 13:11
I can't say for sure, I never used them. I have my storage in a NAS.
And a 5400rpm disk is more than fast enough, even recording 10 high-end channels will probably not exceed 100Mbps, which is not a problem for a modern SATA disk. It's more likely the SATA port of the SoC will block before the disk does...
Currently in use: VU+ Duo 4K (2xFBC S2), VU+ Solo 4K (1xFBC S2), uClan Usytm 4K Ultimate (S2+T2), Octagon SF8008 (S2+T2), Zgemma H9.2H (S2+T2)
Due to my bad health, I will not be very active at times and may be slow to respond. I will not read the forum or PM on a regular basis.
Many answers to your question can be found in our new and improved wiki.
Posted 14 June 2018 - 14:02
Posted 14 June 2018 - 18:00
You can also have a look at this in the wiki https://wiki.openpli...ellite_receiver
It comes to the same conclusion 5400rpm is good enough.
Hardware: Vu+ Uno 4K SE - Vu+ Duo 4K - Fuba 78 cm - Tripleblock LNB Quad 19.2/23.5/28.2 - DS918+
Software : OpenPLi - OSCam - Settings van Hans - Autotimer - EPGImport
---------------------------------------------------------------------------------------------------------------------------------------
Remember: Upvote with the 
button for any user/post you find to be helpful, informative, or deserving of recognition!
---------------------------------------------------------------------------------------------------------------------------------------
Many answers to your question can be found in our new and improved wiki
Posted 14 June 2018 - 19:02
7200rpm hdds are not ideal to cases without good ventilation (all boxes, imho). And produce more noise and vibration too.
I am using in all boxes with internal hdd 5400 2,5" WD AV-25 1TB
Posted 14 June 2018 - 19:12
Posted 11 September 2018 - 20:17
0 members, 7 guests, 0 anonymous users
