Forums

@rysiuhelix

it's better to choose 01-60 in blindscan to find more TPs.

But with the scanning step being set up, as suggested above, Blindscan will find transponders with SR small, e.g. 256

Hello!How to enable the clock display during Standby?

Not possible at the moment. Or only manually via telnet.

I tried  Install plugin (systemplugin) vfdcontrol.

 

Then MENU => SETUP => SYSTEM => VFD Display Setup to configure

 

But it doesn't work at all.

Edited by jpuigs, 4 March 2020 - 18:18.

Thanks a lot.

 

I used the Stream button on openwebif. Now i use Stream (transcoded), open stream with vlc and so far no problem.

Vlc URL: http://192.168.2.90:...38;interlaced=0

 

I tried to do normal streaming (not transcoding) via OpenWebif on laptop with the receiver in standby mode and it played without any problem.

Not possible at the moment. Or only manually via telnet.

How to setup via Telnet? Thank you.

Try this
echo “on” > /proc/stb/fp/power4x7standby

Try this
echo “on” > /proc/stb/fp/power4x7standby

don't work. in /proc folder and in all subfolder all files are 0 byte .

i change permission to 755 and 777 but is impossible write in this file .

 

Try this
echo “on” > /proc/stb/fp/power4x7standby

solved 

 

echo on > /proc/stb/fp/power4x7standby

not

echo “on” > /proc/stb/fp/power4x7standby

 

 

These are not files, these are driver proc nodes, a pipe into the drivers.

 

A write to it sends data to the drivers, a read from it read data from the drivers. File attributes (like size and timestamp) are not relevant.

Multibootimage don´t run with openATV in Flash.

sorry, now it runs

Multibootimage don´t run with openATV in Flash.

Multiboot doesn’t work at all. That is work in progress but we’re waiting for response from the manufacturer regarding this.

 

Multiboot doesn’t work at all. That is work in progress but we’re waiting for response from the manufacturer regarding this.

 

 

Hi everybody and thank you for the firmware,

 

Can anybody check if extension "audio sync" is actually doing anything when applying any positive or negative delay? It doesn't look to work at all. I have been using this plugin nicely in other boxes to fix the lip delay in some channels, but with the SF8008 it just doesn't have any effect.

 

The way it should work is: install from plugins/extensions "audio sync".

Audio menu, under ac3 downmix, dts downmix, audio channel and bypass HDMI EDID check, there's the Audio Sync option. Click OK and there up and down the delay scroll to set a service delay and hit OK to save. Even without saving, it should be delaying the audio, in my case, not working.

 

thank you!

hello

having previously installed the satdream image, now that the openpli is available I mounted it, but being the larger satdream, at the start before the openpli splash, the satdream splash appears for a few seconds, could it be avoided?

https://github.com/s...tions-sf8008.bb

 

SRC_URI = "http://source.mynonp...${SRCDATE}.zip"

 

VS

 

https://github.com/z...tions-sf8008.bb

 

SRC_URI = "http://source.mynonp...${SRCDATE}.zip"

 

 

No comments....

how you get the time on the display when the decoder is in stanby?

Edited by isteric2005, 9 March 2020 - 23:11.