Hello everyone.
First of all, a massive thank you and heartfelt gratitude to the OpenPLi team members for continuously providing the most reliable enigma2 image :-).
In a Vu Duo 4K with one FBC DVB-S2X tuner and one Dual DVB-T2 tuner MTSIF, there was the need to add a dual DVB-T/T2/C USB tuner for multiple simultaneous recordings. After searching on linuxtv.org, it seemed the only one available for sale with good linux support is the Hauppauge WinTV-dualHD. Single USB tuner Hauppauge WinTV-SoloHD is already supported by enigma2-plugin-drivers-ct2-dvb-usb-pctv292e.
OpenPLi team members are absolutely correct in that using USB tuners are asking for trouble but sometimes it is a solution.
On https://github.com/O...penpli-oe-core/ there is a HauppaugeWinTV-dualHD.patch which adds support to the following brands but not to Vu+:
meta-gfutures/recipes-bsp/linux/files meta-gigablue/recipes-bsp/linux/linux-gigablue-4.4.35 meta-maxytec/recipes-bsp/linux/files meta-octagon/recipes-linux/linux-octagon-4.4.35 meta-uclan/recipes-linux/linux-uclan-4.4.35 meta-zgemma/recipes-bsp/linux/files
To be able to use it on the Vu receiver, the attached patch was made from scratch and it only includes the kernel commits at the end of this post, some newer than the HauppaugeWinTV-dualHD.patch. The patch was copied to meta-vuplus/recipes-bsp/linux/linux-vuplus-4.1.45/ and added to meta-vuplus/recipes-bsp/linux/linux-vuplus-4.1.45.inc below the line: file://0017-mn88472-finalize-driver.patch \ as file://0018-Add-support-for-dvb-usb-stick-Hauppauge-WinTV-dualHD.patch \.
The compiled driver was tested extensively, even with 4 HD recordings and there are no problems, even when zapping while recording.
Before using the WinTV-dualHD, please make sure it is in bulk mode as on https://www.linuxtv....er_Mode_to_bulk (download https://www.hauppaug...n=FAQ.BulkOrIso and set it to bulk mode).
To install the driver, download and unzip the attached enigma2-plugin-drivers-ct2-dvb-usb-hauppauge-dualhd.zip file, ftp the ipk files to /tmp and run:
opkg install --force-reinstall /tmp/*.ipk
Then reboot the receiver. After it boots, go to tuner configuration to enable the two WinTV-dualHD tuners.
If it is useful to others, I hope OpenPLi would include the patch sometime in the future. Perhaps in a duplicate package of enigma2-plugin-drivers-ct2-dvb-usb-pctv292e, maybe with the name enigma2-plugin-drivers-ct2-dvb-usb-hauppauge-dualhd so that it is a little bit clearer to the end user.
Also, as I am not that familiar with PR and Vu will probably ignore a patch from an unknown contributor, I would be grateful for a kind OpenPLi team member to PR directly to Vu+ so that they can add it to meta-vuplus.
Thank you very much again for all your hard work.
0018-Add-support-for-dvb-usb-stick-Hauppauge-WinTV-dualHD.patch commits https://github.com/torvalds/linux/commits/master/drivers/media/dvb-frontends Commits on May 21, 2019 media: si2168: add frequency data to frontend info Commits on Mar 6, 2018 media: si2168: change ts bus control logic media: si2168: Add spectrum inversion property media: si2168: Announce frontend creation failure media: si2168: Add ts bus coontrol, turn off bus on sleep Commits on May 12, 2015 [media] si2168: add support for gapped clock https://github.com/torvalds/linux/commits/master/drivers/media/tuners Commits on Feb 1, 2016 [media] si2157.c: fix frequency range Commits on May 12, 2015 [media] si2157: support selection of IF interface https://github.com/torvalds/linux/commits/master/drivers/media/usb/em28xx Commits on Feb 5, 2021 media: em28xx-core: Fix TS2 active led Commits on Aug 14, 2019 media: em28xx: modules workqueue not inited for 2nd device Commits on Jul 30, 2018 media: em28xx: disable null packet filter for WinTVdualHD media: em28xx: explicitly disable TS packet filter Commits on Jul 27, 2018 media: em28xx: Fix DualHD disconnect oops media: em28xx: Fix dual transport stream operation Commits on May 11, 2018 media: em28xx: Demote several dev_err to dev_info Commits on May 4, 2018 media: em28xx: fix a regression with HVR-950 media: em28xx: Don't use ops->resume if NULL Commits on Mar 8, 2018 media: em28xx-cards: fix em28xx_duplicate_dev() Commits on Mar 7, 2018 media: em28xx: Change hex to lower case Commits on Mar 6, 2018 media: em28xx: Enable inversion for Solo/Dual HD DVB models media: em28xx: Enable Hauppauge SoloHD rebranded 292e SE media: em28xx: Add Hauppauge SoloHD/DualHD bulk models media: em28xx: Increase max em28xx boards to max dvb adapters media: em28xx: USB bulk packet size fix media: em28xx: Bulk transfer implementation fix media: em28xx: Hauppauge DualHD second tuner functionality Commits on May 9, 2016 [media] em28xx: add support for Hauppauge WinTV-dualHD DVB tuner
Attached Files
-
enigma2-plugin-drivers-ct2-dvb-usb-hauppauge-dualhd.zip 61.49KB
67 downloads
-
0018-Add-support-for-dvb-usb-stick-Hauppauge-WinTV-dualHD.patch 28.2KB
31 downloads
