2 replies to this topic

[goodstuf]

Sorry all if this question has been asked before but can’t seem to find pervious posts to this question.
My bloody power board that my dream was plugged into melted. The software pli jade I was running on the db. became corrupt. I used dream up to flash/erase and reinstalled P.L.I Jade
But I can’t seem to get the [new] external card reader to work.
I’m must be missing a command line in my cccam. Config file.
Can some one please tell me if I can just put in the command line needed & do I have to edit another file? When I go into soft cam set up in card server it has none. it did prior to burn out :
Thank you in advance

[jonc]

as this subject is kinda breaking our rules (feel free to read them) I would suggest you try this topic again but on a local web board there in Oz - http://www.austech.info/dreambox/ where you will get this answered

[goodstuf]

sorry