Posted 15 December 2021 - 19:38
The splitter remark I made was in relation to Unicable, where it is normal to use splitters.
For legacy setups, you'll have to be careful with LNB power, besides switching issues. It is possible (I've used a provider box without DiseqC support on a multiswitch this way), but make sure you know what you're doing !
Currently in use: VU+ Duo 4K (2xFBC S2), VU+ Solo 4K (1xFBC S2), uClan Usytm 4K Ultimate (S2+T2), Octagon SF8008 (S2+T2), Zgemma H9.2H (S2+T2)
Due to my bad health, I will not be very active at times and may be slow to respond. I will not read the forum or PM on a regular basis.
Many answers to your question can be found in our new and improved wiki.
Posted 15 December 2021 - 23:29
Unicable is not designed for a motorised dish. You are not meant to have two receivers connected to one motorised dish. However, you can make it work provided you move dish back to the position you have set unicable on. Draw a picture/diagram of what you are intending to do, your initial description sounds almost right apart, but best to avoid confusion.
How many legacy/universal outputs does the LNB have?
Have you tried the blind scan on the Duo 4K while connected to the universal port of LNB?
Posted 16 December 2021 - 13:31
Unicable is not designed for a motorised dish. You are not meant to have two receivers connected to one motorised dish. However, you can make it work provided you move dish back to the position you have set unicable on. Draw a picture/diagram of what you are intending to do, your initial description sounds almost right apart, but best to avoid confusion.
How many legacy/universal outputs does the LNB have?
Have you tried the blind scan on the Duo 4K while connected to the universal port of LNB?
The LNB is a GigaBlue Ultra Unicable SCR-LNB / 24 SCR - 2 Legacy UHD. The problem is "I am not allowed" to add an extra cable to the legacy outputs and my main receiver "the vuplus" does work fine with the current setup which uses a unicable setup. I just wonder what would happen (even though this is indeed not a correct practice) if you connect the cable from the lnb to the splitter and from there make one connection to the zgemma and another to the vuplus? Will this give magic smoke when both receivers try to drive the dish to different positions? Can I adjust a setting in the zgemma such that it never can perform such an action and just "listens" to the signal available for the position which the vuplus has driven the dish to? Would adding a DC-blocker in the cable for the zgemma be something to consider?
kind regards,
jean
auto run command on startupStarted by kemoogo, 12 Nov 2022  vu+ duo 4k se, openpli 8.3
|
|
|
||
Flashen nieuwe imageStarted by jootje, 22 Oct 2022 VU+ Duo 4K SE
|
|
|
||
Problemen met configuatie van TV Portal op Zgemma H9S SEStarted by jeandubois, 23 Dec 2021 Zgemma H9S SE
|
|
|
||
no parse cannot emu met OpenPli8.1Started by jeandubois, 6 Nov 2021 vuplus, VU+ Duo 4K SE and 1 more...
|
|
|
||
VU+ DUO 4K SE - Satellieten toevoegen?Started by Herman-65, 2 Apr 2021 VU+ DUO 4K SE
|
|
|
0 members, 3 guests, 0 anonymous users
