4 replies to this topic

[CrowHater]

Suddenly it stopped working.

both red...green and yellow//orange led is lit at the same time but weak.  When powering on they all turns on after 2-3 seconds.

Remember that I had this issue once before but that was a couple a years ago.   But do not remember what the solution was.

Tried to put in a usb stick with new bootloader OR image to see if it will recognize and start update but nothing.

Anyone with same issue and how did you solve it?

Thanks....

Edited by CrowHater, 20 August 2022 - 20:23.

[Frenske]

I’m afraid that the number of et6000 users are very limited if not be zero on our board so the number of replies might be disappointing too.

[rantanplan]

What image did you try?

Current images bypass the bootloader (Sec board).

[mimisiku]

Defective powerboard (easy fix) or worst case scenario loose contacts under the SoC (needs reballing).. Powerboard can be easily fixed by replacing bad capacitors. Reballing needs specialistic equipment…

[CrowHater]

Defective powerboard (easy fix) or worst case scenario loose contacts under the SoC (needs reballing).. Powerboard can be easily fixed by replacing bad capacitors. Reballing needs specialistic equipment…

Have all the voltages across the whole board.  Must be some problem with some chip... i´ll try to reheat the chips with flux and then we will see.  Before i had som problem with a mosfet and that one i changed and it worked after that. But now all the mosfets are ok.