4 replies to this topic

[arin66]

I've tried to flash openpli 8.3 for my zgemma h5, from the menu in the gui, after making a backup. (as in the first screenshot on https://wiki.openpli.../Installation).

A progress bar titled ofgwrite informed me about the process and then aborted with an error.

From that point on, I was unable to boot my h5. When I power on, the title "boot" appears on the box display but nothing happens.

How can I try another flashing without the gui (since openpli does not load anymore)?

Page https://wiki.openpli.org/Zgemma reports instructions for all zgemma models apart h5.

Thank you for your help.

 

[WanWizard]

• Download the zip and unzip it onto a FAT32 formatted USB stick
• Plug the stick into the USB port at the BACK of the box, do not use the front port
• Wait for "USB" to appear on front display
• Immediately press power button on front
• "FLSH" should appear to indicate it is flashing

[arin66]

Thank you, after several tempatives I've successful flashed openpli 8.3 using an old usb pendrive formatted in low mode.

Previously I made a backup. Is it possible to restore all my configuration? Using with pathe on the gui?

Thank you.

[arin66]

Done. I've reflashed oopenpli 8.3 using the same pendrive after having copied the backup file. Thank you for your support.

[WanWizard]

If you configure autobackup (in the setup menu), you don't have to do than manually anymore. And autobackup backups are automatically restored after a flash.