4 replies to this topic

[bestofcomputer]

how to prevent deactivated record programings from auto activate after reboot from power cut ?

my octogon sf8008 has 3 record programmings that should occur everyday.

but i dont need them for the moment.

so i just deactivated them.

it is fine like that.

until there is a power cut.

then when the power comes back my octagon retarts and suddenly it reactivate itself automatically all the record programming and they start recordong right away, until i notice the problem, then i deactivate them again (and all their occurences) and its fine until next power cut and the problem happens again.

how to correct that faulty behaviour ?

i have open pli 8.3 from march 2023.

one more question :

why is my octagon starts power ON after a reboot from power cut ?

how to change that behavious so that after a power cut and after a reboot it remains OFF ?

and one more question :

the default behaviour seems to be  that my octagon stops any recording in case of any signal loss.

this is anoying me a lot, so how to chang that behaviour so that any recording will proceed until the timing i decided it to end even in case of any signal loss and whatever long is that loss ?

thanks.

[Trial]

Hi,

normally changed settings are only stored if you really power down/restart the box or restart enigma2. So if your box always is in stand by the changes are volatile.

 

Direct restart powered of is not possible I think. A plugin startuptostandby will set your box to standby after every restart.

 

Ralf

[littlesat]

Timers are stored in an xml not as a setting.
When ag a plugin modifies a setting (which is not the case here) the plugin should save the settings.
The behavior for power on after reboot/powercut is a configuration that can be set.

Edited by littlesat, 4 June 2023 - 08:26.

[bestofcomputer]

ok.

but where is this startuptostandby plugin and how to install it ?

i still have the problem of my recordings starting automatically without my consent.

and my recordings aborting in case of signal loss.

[Dimitrij]

menu -->"Customize"-->"Startup to Standby"