I have some problems when I use backward and forward jumps in MoviePlayer and CutListEditor.
1. With the 1 and 3 touches, it jumps backward 12 seconds and forward 10 seconds.
I detected this problem since I used the Vu+. With the Xtrend, the jumps seemed to be the same backward and forward.
It was annoying but not dramatic but I should want to correct it.
2. In CutListEditor, it does not cut where I press "OK" because there are 2 counters for the same point in the movie as you can see in the picture and there is ~2 seconds difference. It's not convenient at all to have the good cut because it cuts with the mark on the left list while the good mark is under the picture.
3. I sought in CutListEditor files and I found keymap.xml. Then I could see there are options I did not know about as left and right touches to jump 1 second backward and forward.
Then I did other tests and I detected the jumps are approximate and not exactly with the requested value. There is an error of 1~2 seconds. Not very well to get the good mark.
I tried an application on the PC and the jumps seem to be good but it's not convenient to use the PC and the application is not as user-friendly than CutListEditor. In addition, it can only cut at the beginning and at the end of the file.
I've done some corrections in the keymap.xml and I've added additional jumps with "2", "5", "8" touches.
With the left touch, it jumped backward ~2 seconds and ~1 second backward with the right touch. Then, I replaced "seek:-1" with "seek:0" and "seek:1" with ""seek:2". But sometimes, it didn't work well. Then I tried "ReconstructApSc" and it seems to solve this problem but it's not convenient to use it on a lot of files. I have also modified the other standard touches.
I should also want to modify the MoviePlayer jumps to avoid asymmetric jumps but I haven't found the files of this application.
Thank you for your help.