Jump to content


p30n

Member Since 31 Mar 2008
Offline Last Active 12 Mar 2020 18:03
-----

Posts I've Made

In Topic: Vu+ Solo SE v2 with twin tuner and USALS

16 May 2016 - 20:08

General rule of thumb.

 

If your single tuner card has an output, then it wont loop through internaly.

 

Xtrend say the same in their blurb (manual).

 

Get an external F-jumper lead (out to in) and in settings for second tuner set same as tuner A

 

My box does NOT have any outputs, only lnb A IN and lnb B IN, and additionally it should do the "internal loopthru" as the salesman told me ?

 

I can not loop it externally as you proposed, this worked on my old box that had 2 physical tuner cards with both in and out but not on this Vu+

 

The receiver shows Tuner A and Tuner B in OpenPLi tuner setup so now I am pondering the settings in PLi for getting the internal loop to work, I have not tried with a static feed from the dish only with the USALS settings and maybe this is the culprit why it is not working? I need someone to confirm the internal loopthru works with motor setups also.

 

thanks tho!


In Topic: VU SOLO SE v2 - NOPT RECORDING nor STREAMING, pau?!

16 May 2016 - 19:02

wow I feel like a complete retard.
might have been because of me being at work pondering what to do with the box when I got home...but as you advised, PAU is the answer.

 

Thanks for pointing out the obvious, its working as it should now :)

 

Only one thing left then, to figure out how to configure my motorised dish signal to split internally since I have a twin tuner in the vusolose v2 and I'd like to record and watch different channels with the help of this without having to get a dual lnb and put another cable from dish.

Anyone have experience with this particular box and twin tuner+motor?

 

thanks again!