I tried to install iptables on my vusolo2 but the kernel seems not to support this funktion.
root@vusolo2:~# opkg install iptables
Installing iptables (1.4.21-r0.0) on root.
Downloading http://downloads.pli-images.org/feeds/openpli-4/mips32el/iptables_1.4.21-r0.0_mips32el.ipk.
iptables: unsatisfied recommendation for kernel-module-nf-defrag-ipv4
iptables: unsatisfied recommendation for kernel-module-nf-conntrack
iptables: unsatisfied recommendation for kernel-module-ipt-masquerade
iptables: unsatisfied recommendation for kernel-module-x-tables
iptables: unsatisfied recommendation for kernel-module-nf-nat
iptables: unsatisfied recommendation for kernel-module-nf-conntrack-ipv4
iptables: unsatisfied recommendation for kernel-module-iptable-nat
iptables: unsatisfied recommendation for kernel-module-ip-tables
iptables: unsatisfied recommendation for kernel-module-iptable-filter
Configuring iptables.
When i try to add a rule:
modprobe: FATAL: Module ip_tables not found.
iptables v1.4.21: can't initialize iptables table `filter': Table does not exist (do you need to insmod?)
Perhaps iptables or your kernel needs to be upgraded.
I use my solo2 as openvpn server and want to block all Ports on the tun device. The Clients need to connect to one or two ports and this ports will be defined in a rule.
Is it right that i need to build the Image from source including the kernel modules?
Would be nice if the modules could be implemented in the future.
TechniSat Multytenne Twin: 19,2°E | 13,0°E | 23,5°E | 28,2°E -> OpenPLi4.0@vusolo2
Multifeed Offset: 19,2°E | 13,0°E | 4,8°E | 5,0°W -> OpenPLi4.0@dm800se + OpenPLi4.0@vuzero