4 replies to this topic

[francais_canada]

I have got a Motorized Dish with KU as well as C band LNBs. I was using Enigma before switching over to Gemini and now finally to PLi !!

Both in Enigma as well as Gemini, there was an option of "Multiple Satellites" where we used to select KU band LNB as 1 and C Band as 2 ...... then we tune in different satellites and give them LNB1 or LNB2 as per the status !!

However, in PLi, I am not able to see any such option ..... can anybody guide me as to how can I do this ??

1. LNB1 = KU Band
2. LNB 2 = C Band
3. Tune multiple satellites for LNB1 as well as LNB2

Thanks.

[francais_canada]

SORRY guys ........ Problem SOLVED !! Just needed to hang around PLi a little bit and found the option !!

[hemertje]

could you tell you solution here, so others might find there solution here to

thx

[jonc]

Read the wiki >> E1SatRotor <<

[francais_canada]

could you tell you solution here, so others might find there solution here to

thx

Yeah Sure Hemertje ...... here it is :

1. forget the start-up dialogue; ignore it !!
2. when in PLi; go to start-up and Satellite configuration - select the last options - multiple satellites
3. add all satellites in the next dialogue box ..... ALL Sats will be on default LNB0
4. check your Diseq switch to see on which port is your KU & on which port is yr C Band.
5. change the characteristics of LNB .... suppose LNB0 is KU Band .... leave it as default ..... LNB 1 is C Band .... change the first 2 parameters of LNB as 5150 - both
6. In this way, your satellite config page will be showiong all satelittes with their own respective LNBs
7. move yr dish to the sat u want to configure and start scanning

As I am a newbie is this sat field ..... thus I tried to write as I explained it to my bro !!

Thanks !!