plasticassius

Version 7.0 20190121054719 behaves the same way as 6.2

I upgraded to 7.0 version 20190121054719, I couldn't figure out how to post a thumbnail, but I get the same thing as in message #1, including the stuff about unknown operand and fuse file system. None of that seems to matter, though. It continues to boot and operate correctly. I have one ext4 partition on my mmc card, and it works properly as well.

Sorry if I'm creating work for you, but of course I don't want you to do work for nothing...

I tried the firmware but, I'm afraid there's another problem:

modprobe em28xx card=94
echo "2040 8268" > /sys/bus/usb/drivers/em28xx/new_id

[  128.599000] usbcore: registered new interface driver em28xx
[  146.493000] em28xx 1-1:1.0: New device HCW soloHD @ 480 Mbps (2040:8268, interface 0, class 0)
[  146.493000] em28xx 1-1:1.0: DVB interface 0 found: bulk
[  146.493000] em28xx 1-1:1.0: chip ID is em28178
[  148.503000] em28xx 1-1:1.0: EEPROM ID = 26 00 01 00, EEPROM hash = 0x69cec080
[  148.503000] em28xx 1-1:1.0: EEPROM info:
[  148.503000] em28xx 1-1:1.0: 	microcode start address = 0x0004, boot configuration = 0x01
[  148.516000] em28xx 1-1:1.0: 	AC97 audio (5 sample rates)
[  148.516000] em28xx 1-1:1.0: 	500mA max power
[  148.516000] em28xx 1-1:1.0: 	Table at offset 0x27, strings=0x0e6a, 0x1888, 0x087e
[  148.517000] em28xx 1-1:1.0: Identified as PCTV tripleStick (292e) (card=94)
[  148.517000] em28xx 1-1:1.0: dvb set to isoc mode.
[  148.586000] em28xx 1-1:1.0: Binding DVB extension
[  148.587000] ------------[ cut here ]------------
[  148.587000] WARNING: CPU: 1 PID: 556 at /openpli/oe/release-6.2/build/tmp/work-shared/h5/kernel-source/mm/page_alloc.c:3541 __alloc_pages_nodemask+0x3a8/0xc6c
[  148.587000] Modules linked in: em28xx_dvb(+) em28xx tveeprom nfsd ipv6 h5(FO) h5_3(O) h5_2(O) h5_1(O)
[  148.587000] CPU: 1 PID: 556 Comm: modprobe Tainted: GF          O    4.10.12 #1
[  148.587000] Stack : 00000000 00000000 809c7d9a 00000043 00000000 809c7d98 808ac520 00000009
[  148.587000]         aee83064 8092f167 8087201c 00000001 0000022c 809c384c 00010000 ac8889d8
[  148.587000]         aca5a800 80080374 00000000 0000000a 809c7d9a 00000000 80878d44 aca7f994
[  148.587000]         00000003 800cbd34 00000009 00000dd5 00000021 00000000 aca7f994 aee82d00
[  148.587000]         00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000
[  148.587000]         ...
[  148.587000] Call Trace:
[  148.587000] [<8000f91c>] show_stack+0x88/0xa4
[  148.587000] [<803b8e78>] dump_stack+0xd8/0x110
[  148.587000] [<80028464>] __warn+0x104/0x118
[  148.587000] [<80028508>] warn_slowpath_null+0x1c/0x34
[  148.587000] [<800d972c>] __alloc_pages_nodemask+0x3a8/0xc6c
[  148.587000] [<80017ca4>] mips_dma_alloc_coherent+0xd0/0x2ac
[  148.587000] [<8051cda4>] hcd_buffer_alloc+0xb8/0x1a0
[  148.587000] [<e1fd7d3c>] em28xx_alloc_urbs+0x214/0x4d0 [em28xx]
[  148.588000] [<e1ffd888>] em28xx_dvb_init.part.3+0xb4/0x30bc [em28xx_dvb]
[  148.588000] [<e1fd625c>] em28xx_register_extension+0x6c/0xc0 [em28xx]
[  148.588000] [<800015d8>] do_one_initcall+0x44/0x18c
[  148.588000] [<800cc080>] do_init_module+0x74/0x1d4
[  148.588000] [<800b3648>] load_module+0x2450/0x26f8
[  148.588000] [<800b3b7c>] SyS_finit_module+0xc8/0xe8
[  148.588000] [<80015d84>] syscall_common+0x34/0x58
[  148.588000] ---[ end trace fe1801519c563a90 ]---
[  148.588000] em28xx 1-1:1.0: unable to allocate 654573568 bytes for transfer buffer 0
[  148.590000] em28xx 1-1:1.0: failed to pre-allocate USB transfer buffers for DVB.
[  148.590000] em28xx: Registered (Em28xx dvb Extension) extension

# opkg install firmware-dvb-demod-si2168-b40
Installing firmware-dvb-demod-si2168-b40 (1.1+git292+25f936b) on root.
Downloading http://downloads.openpli.org/feeds/openpli-6-release/all/firmware-dvb-demod-si2168-b40_1.1+git292+25f936b-r0.3_all.ipk.
Configuring firmware-dvb-demod-si2168-b40.

# opkg install firmware-dvb-tuner-si2158-a20
Installing firmware-dvb-tuner-si2158-a20 (1.1+git292+25f936b) on root.
Downloading http://downloads.openpli.org/feeds/openpli-6-release/all/firmware-dvb-tuner-si2158-a20_1.1+git292+25f936b-r0.1_all.ipk.
Configuring firmware-dvb-tuner-si2158-a20.

Neither of these packages helped.

I noticed that Openpli 6.2 has kernel 4.10, and my Raspbian image has kernel 4.14. So, I have the feeling that a more recent kernel has driver fixes for this. Now I think that trying Openpli 7.0 has some logic to it since it must have a more recent kernel. (Is that true?)

# opkg install firmware-dvb-fe-si2168
Collected errors:
 * opkg_prepare_url_for_install: Couldn't find anything to satisfy 'firmware-dvb-fe-si2168'.