sungwutang

Hello Open PLi developers,

I am having two issues with my Xtrend box. I was wondering if you, developers, can include the following changes/fixes in the newest open PLi image for Xtrend ET9x00/6x00/5x00:

1. When you go to stand-by mode from Diseq 1.2 motor, the motor shuts off as well. Would it be possible to make the following change: to continue to carry out the existing commands- even after going to stand-by mode, the motor should move until the end.

2. While the motor is moving, when you press “scan ok” scan is entered while motor is moving --> The scan should be entered after the motor has finished moving.

As far as I know, these two issues have to do with the E2.
Please let me know if these fixes can be included in the newest open PLi image for Xtrend.
Thank you for your efforts and help.

Best Regards,
Sungwutang

Hello PLi forum

I just found out that there is a new version of the et-webbrowser available on the OpenPLi feed (downloadable plug-in list)
http://www.et-view.d...2.html#post4887
What is the main difference between the newest version of the et-webbrowser and the previous version?
Does it fully support USB-HID?
Is it only applicable for the et9x00? Or is there also the et-webbrowser availble for the et6x00 on the OpenPLi feed?
And is it possible to find out if there is a separate webbrowser.ipk file available for et6x00?
Please let me know. Thank you

Hello I have an urgent question:

I have Xtrend et9200.

there is open VPN in PLi image somewhere I heard but I am not sure how to install it.
In Gemini image Open VPN can be installed very easily but in PLI I have had no success.
Can anyone explain how this process works?
Thank you in advance.