Ylinenjarvi

I tried it anyway, flashed the Official image, started up the box before flashing it back with OpenPLI 3 again...

It did not work any better...

Mate try install another image and after that try install openpli again i think it will fix your problem best way to flash is that you switch off and then keep power down and switch button on!! Flash with internet by ip

Regards

That makes absolutely no sense at all, how would a previous reflash affect the current one?

Anyway, it worked for 6 days and now I'm back to a box that freezes after the second boot-screen shows.

How about these then. Have you anything connected to USB? Remove it.

[    0.649000] hub 1-0:1.0: over-current condition on port 1
[    0.851000] hub 1-0:1.0: over-current condition on port 2
[    1.056000] hub 2-0:1.0: over-current condition on port 1
[    1.660000] hub 3-0:1.0: over-current condition
[    2.264000] hub 4-0:1.0: over-current condition

If it's a hardware issue I'll replace the entire box.

But every time it stops working it works fine for about a week if i re-flash it.

That alone makes me doubt it's a hw-issue.

I'm using todays build on the box.

Only plugin I've installed is Mgacamd 1.35a from Plugins-screen, I would assume someone else tried that softcam on OpenPLI 3.0?

As I mentioned earlier it's not a clone receiver, the only thing I restore from backup is the bouqets and mgacamd configuration-files.

I've suspected hardware-issues but if it was the hardware why would it work for about a week every time i re-flash it?