SpliNT

Hello, i'm losing my mind a little bit over this so some feedback would be awesome.

My setup looks like this:
Dish with 2x Quad LNB which are set in fixed positions to two different satellites.
Quad LNB 1: Thor 0.8W
Quad LNB 2: Astra 4.8E

Vu+Duo2 with Open Pli 4 (OpenPLi-4.0-beta-vuduo2-20160701)
Twin tuner (S2) 1 (A + B ) = 2 cables from LNB 1
Twin tuner (S2) 2 (C+D) = 2 cables from LNB 2

Tuner config looks like this:

I have backuped bouquets I'm using.

I've done a manual scan on Tuner A for Thor 0.8W and afterwards a manual scan for Tuner C for Astra 4.8E.

Directly after scanning Tuner C (Astra 4.8E) it looks like this:

As you see here, tuner C works and D immediately become unusable.

When I change channel to Tuner A (Thor 0.8W) C & D immediately become unsuable,
as if they're being used.

Switching back to the previous channel on LNB2 Astra (4.8E) gives me

I've tried moving the cables from LNB 2 to Twin Tuner 1 and LNB 1 to Twin Tuner 2

and I got the same results but the opposite, causing A & B to become unusable while C & D on work.

I also tried changing one the twin tuners with a brand new one, same thing.

No luck with OpenVix or Blackhole, different versions of softcams.

This used to work fine between 2014 (when I bought it) and 2015.
I'm wondering if it could be bad drivers maybe?

What are your thoughts on this? Any ideas are appreaciated.

Thanks in advance.

I ran into a problem yesterday.

After a reboot of the Vu+Duo2 (OpenPli 4) Webif got inaccessible. Everything else, OScam, FTP, telnet etc. seems to running fine.

I have custom ports on everything, webif, telnet, ssh, ftp and is behind NAT.

The thing is that the box is placed on a remote location (an island in fact) so I have no physical access to it. Therefore Webif is essential. 

I have a PC in the local network of the box so I can reach it from inside if needed.  

I have tried the following without any success:

opkg update
opkg upgrade

root@vuduo2:~# opkg remove —force-depends enigma2-plugin-extensions-openwebif
Removing package enigma2-plugin-extensions-openwebif from root...
root@vuduo2:~# opkg install enigma2-plugin-extensions-openwebif
Installing enigma2-plugin-extensions-openwebif (1+git1332+3f47ff8-r0.1) on root.
Downloading http://downloads.pli-images.org/feeds/openpli-4/vuduo2/enigma2-plugin-extensions-openwebif_1+git1332+3f47ff8-r0.1_vuduo2.ipk.
Configuring enigma2-plugin-extensions-openwebif.
root@vuduo2:~#

If you'd like to see logs I can pull them out for you, just tell me where.

Thanks in advance!