It should be a normal S2 carrier.
People in the right place (not me) like you are able to get a lock on it.
In some moments the TP has briefly been off, so that can be an option.
4 February 2024 - 15:47
It should be a normal S2 carrier.
People in the right place (not me) like you are able to get a lock on it.
In some moments the TP has briefly been off, so that can be an option.
4 February 2024 - 10:47
It seems to be a transponder very difficult to catch outside roughly the area normally served by the original FreeSat service.
It is a no go for East/SE Europe.
It is also interfered with by signals at near frequencies on different beams of the same satellite. So, a 15 m dish might not help if you are in the wrong place.
I fear it was good until it (will) last.
I seize the occasion to send again many thanks to the people who here helped to have this service available soon after FreeSat transferred in its narrow beam.
I still hope that someone can come out with a similar new bright idea, at least for the people in the right places for this new service, but no one can easily fight against physics for the others.
29 December 2023 - 16:22
I apologise if this question will appear lame and/or very old.
Actually, I have seen right now (I am writing this on top, but as last edit to my post) that I already put this question a couple of years ago, but I received no answer.
I am getting Satback OK since the very first moment the remedy was found by doublet&C.. So, no problem in this.
I can also (usually) edit lamedb properly to achieve the result.
But if I then edit my channels with DreamBoxEdit (7.2.1.0), some of the extra parameters get stripped.
This is very inconvenient, since reduces a lot my flexibility to update the channel list, other than from the receiver itself.
Even in this thread (very many many) pages up (page 4), at the time when the trick had not been discovered robbie says that DreamBoxEdit keeps all extra options.
But this does not happen in my case, at least not in the way I am using it (pretty standard: load->edit->save, and then the standard procedure to upload it to the receiver by FTP).
After saving, some extra options are not there any more and lamedb needs some editing (again).
Am I missing something? Is there a way/other software to freely edit the channels without damaging BBC entries after the first necessary editing "by hand" in lamedb?
Thank you!
13 June 2023 - 19:29
Hi! Since this morning, I don't receive this satellite. 1.2M in Canary Islands. Since the first blackout few weeks ago, the signal lowered a bit, but now, nothing.
At the lower limits 8 dB SNR, but receiving it.
Central Italy, bad weather and clouds, Channel Master 1.8 m
25 May 2023 - 18:20
Fine here.