idomonkos

I had the same problem after updating to 7.3 from 7.2 (UNO 4K SE, small front LCD blank, power led always on - in standby, too)

+ there is some problem with vtuner. I had 4 sat>ip tuners 2+2 dvb-t and dvb-c on PLI 7.2. After update to 7.3 they all went missing and the sat>ip client says no vtuner found.

I'm still investigating the problems, but I had to reflash to fix the problems.

After reflash I can open the sat>ip config, but if I setup all 4 tuners and reboot, I get no vtuner found again. I think I had some success with only 2 dvb-c tuners, but I must try it again. Where are the log files for this?

Hi, 

 

I too have display problem after 7.2 -> 7.3 flash (and restart) : Display shows only static boot-rings, even in standby.

 

My receiver is an old VU+ Ultimo.

 

It seems that /dev/dbox/oled0 is missing (There is /dev/oled0 instead). VU plus specific plugin LEDbrightnesssetup needs it.

 

Doing 'mkdir /dev/dbox', and 'ln /dev/oled0 /dev/dbox', and restarting enigma brang the display back, but this is not proper fix.

 

I hope this helps.

Thank You for developing excellent software !

I want to use it for dvb-t and dvb-c.

Update: with minisatip as a server everything works, I can scan the channels, too.

The tuners are created, but the scan can't find anything and this is added to the log:

Jan 20 23:01:58 vuuno4kse user.warn kernel: [  841.348552] BRCM brcm_dvb0: DVB: adapter 0 frontend 0 frequency limits undefined - fix the driver
Jan 20 23:02:05 vuuno4kse user.warn kernel: [  847.893119] BRCM brcm_dvb0: DVB: adapter 0 frontend 0 frequency limits undefined - fix the driver
Jan 20 23:02:10 vuuno4kse user.warn kernel: [  852.843293] BRCM brcm_dvb0: DVB: adapter 0 frontend 0 frequency limits undefined - fix the driver
Jan 20 23:02:15 vuuno4kse user.warn kernel: [  857.843892] BRCM brcm_dvb0: DVB: adapter 0 frontend 0 frequency limits undefined - fix the driver

Never mind, It finally found my tvheadend server after I installed the DVBViewer media server on another pc. Magically both of them appeared. Now I only have to figure out how to scan the channels.