sakos

Neither me (because I have no idea about your box) nor OpenPLi team (because they only support boxes listed in the bottom right corner on this website: http://openpli.org/download/)

It means you have simply been tricked into having an OpenPLi image on your box.

Ok. Then I will perform test with a supported box type to see if the issue is HW or SW related.

Your box is not supported by OpenPLi, so I'm afraid you need to seek help somewhere else.

Damn. This box has Openpli preinstalled by factory.

Does your statement mean that you won't help me at all?

Here is the SW and HW info

 version.jpg   11.98KB   13 downloads

It is a Cloud Ibox2 Plus box. I hope that there is no HW limitation.

Can you post a screenshot of your hdmicec settings on the tv and on the stb?

Hi,
 
HDMI-CEC settings on STB:
(Note: It is not clear when the physical address is refreshed. At least it shows the correct value aftre power cycle of the STB. Now, the box is connected to HDMI1 input of TV)

 hdmicec.jpg   26.91KB   34 downloads
 
 
HDMI-CEC (Sony Bravia Sync) settings on TV.
Generic settings

 IMG_20141004_125627878.jpg   40.5KB   20 downloads
 
List of found devices is empty
(It remains empty even after repeated searches)
 IMG_20141004_125610120.jpg   33.9KB   18 downloads
 
STB apperas on the list if STB has a power cycle while the TV is on.
(Even though the STB is present on the list, the CEC control towards the STB is inoperable. The STB entry will be deleted from the list after the TV is put to standby.)
 IMG_20141004_133709396.jpg   27.82KB   18 downloads
 
 
I looked into enigma logs and found log entries when STB is sending volume control commands towards the TV, however I did not find any CEC RX message log entry.
 
eHdmiCEC: send message 44 41 
eHdmiCEC: send message 45 
eHdmiCEC: send message 44 42 
eHdmiCEC: send message 45

Hello,

I would like to ask your support in solving HDMI-CEC interworking issue with OpenPLI4 and a Sony W829 series TV.

What is working 

- TV goes to standby when STB goes to standby 
- TV switches on when STB is switched on

- TV volume can be controlled by STB remote.

What is NOT working
- TV switches to last input when STB is switched on and not to STB input

- Bravia Sync does not discover the connected STB

- STB neither goes standby nor switches on when TV is switched off/on

- Nothing can be controlled on the STB by using the TV remote.

The STB shows 2.0.0.0 address on HDMI1 input.

Could you please give me a hint how to solve or debug this problem? I would like to control the STB via the TV remote only.