Gaston64

Give the lamebd I linked to a try. The one I had earlier worked pre-upgrade, but looked slightly different than the one in the link.

Hello folks;

I had this working for years, but after a software upgrade all is dark.

I have vu+ duo and latest openvix image.

 

Trying to follow the original instructions set that worked in 2015, I can't load oscam ymod onto the current box image.

 

Above it's said that oscam emu will work; I've installed that.

But after 2 days of trying, I haven't got it to work.

 

I have a key file tiled "oscam.keys". I gather in oscam-emu I need a file titled 'softcam.keys'. Can I just rename the file? where should it go?

I did try already...

 

I also have a file called 'script' [contents oscam.sh] and one called 'camscript' [contents Ncam-oscam.sh].

 

I loaded the last working lameb file already as instructed.

 

thanks, gracias, obrigado, merci, etc!

Lamedb entries correct? https://forums.openp...ndpost&p=791234

This file is in \etc\enigma2 and contains info about all channels. You cannot just replace your current file with the one posted at the link, then you will have only 27.5w-channels

You need to edit the current lamedb-file so the 27.5w entries look like the ones on the link. Edited while enigma2 is turned off (init 4).

Maybe it is easier for you to use an editor for lamedb, there are a few but I don't know much about that. Should be covered earlier in this thread.

Which lamedb for VU Ultimo 4K?

https://forums.openp...ndpost&p=791234

 

i didnt realise i didnt need the scripts with 6.1 on a vuzero, so i added them anyway with no conflicting problems, all runs ok

Can you watch one channel and at the same time record a different onefrom 27.5W?

 

I can watch one and stream another, so should work.