I have Vu+Solo2 and PLi.
I have downloaded Oscam through Menue on box and configured the files of Oscam.
I have got the box to read a Canaldigital-card, CAID 0B00, in one of the internal readers. No problems!
But when I try to read a Viasatvard, CAID 090F, It does not work.
The log sais following:
(reader) upper_card_Viasat [internal] card detected
(reader) upper_card_Viasat [internal] ATR: 00 00
(reader) upper_card_Viasat [internal] ERROR: Could not read reader->convention
(reader) upper_card_Viasat [internal] Error activating card.
(reader) upper_card_Viasat [internal] ATR: 00 00
(reader) upper_card_Viasat [internal] ERROR: Could not read reader->convention
(reader) upper_card_Viasat [internal] Error activating card.
(dvbapi) Demuxer 0 no enabled matching ecmpids -> decoding is waiting for matching readers!
(reader) upper_card_Viasat [internal] ATR: 00 00
(reader) upper_card_Viasat [internal] ERROR: Could not read reader->convention
reader) upper_card_Viasat [internal] Error activating card.
(reader) upper_card_Viasat [internal] THIS WAS A FAILED START ATTEMPT No 1 out of max alloted of 1
reader) upper_card_Viasat [internal] card initializing error
The Readersection in Oscam.user looks like this:
[reader]
label = upper_card_Viasat
enable = 0
protocol = internal
device = /dev/sci1
caid = 090F
detect = cd
mhz = 450
cardmhz = 2700
group = 1
emmcache = 1,3,15,0
blockemm-unknown = 1
dropbadcws = 1
ratelimitecm = 4
ratelimittime = 9000
ecmunique = 1
srvidholdtime = 2000
cooldown = 30,600
I have tried to set both mhz and cardmhz to 357 and also deleted them totally, but no progress.
So either the VU+Solo can't read Viasatcards or I am doing something wrong.
How about a external reader connected to USB.
Should the protocol be "smargo"?
What number has the USB on the front? /dev/ttyUSB0 ?
Do I have to install some driver for the USB-reader?