8 replies to this topic

[ROMAN42]

Hello to all , there is some kind of bug on v 6.2 ,on my VU+DUO 2 i have that antenna configuration : A/B is motorised 180 dish with dual LNB and C/D is small dish for 13E with dual LNB and problem is when using Blind Scan plugin to scan A/B tuners ,all channels are found but most of them have shift frequency for about 5 Mhz forward so tuner cannot  tune in to receive channel so i have to scan manually with proper frequency of transponder .I dont check this on tuners C/D but on v 6.1 or 4.0 such stupid problem doesn't exist !!!!! Any suggestion ?    couse i prefer using latest build .By the way to not create new post one small detail is removed from v 6.1/ 6.2, on info bar in FullHD skin on right side above info of using tuners previously show current motorised antenna position !!!! which was very usefull for my configuration antenna's, during using C/D tuners i was able to see on which position leave antenna !!!! Thanks

Edited by ROMAN42, 25 June 2018 - 10:28.

[el bandido]

What antenna settings are you using? Are you trying to blindscan the B tuner?

[ROMAN42]

What antenna settings are you using? Are you trying to blindscan the B tuner?

As i wrote Tuner A is as advanced with motorized antenna  and tuner B is second cable of motorized LNB Tuner A  , so choosing in blind scan tuner A automaticly tuner B should be also scan channels on the same satelite as tuner A is . On build 6.1 all is OK .

Edited by ROMAN42, 26 June 2018 - 12:41.

[el bandido]

Thanks.
Can you blindscan tuner C as a test and see if it is off by the same?
I blindscan a lot. I have no blindscan problems with either version of the OpenPLi image.

[ROMAN42]

Thanks.
Can you blindscan tuner C as a test and see if it is off by the same?
I blindscan a lot. I have no blindscan problems with either version of the OpenPLi image.

Just checked and all seems to be fine on tuner C and D I dont understand this stupid error , some time ago also on v. 4.0 this problem exist but was fixed.

[Huevos]

1) Never blindscan using second tuner of a Vu+ dual tuner. It doesn't work properly.

2) Sounds like the local oscillator in the LNB for tuners A/B is knackered.

[ROMAN42]

1) Never blindscan using second tuner of a Vu+ dual tuner. It doesn't work properly.

2) Sounds like the local oscillator in the LNB for tuners A/B is knackered.

Yes i was thinking the same about this Invacom dual lnb 0.3 db , 12 years maybe enough for him but must check on second.

[Huevos]

If it is a TWF-031 or TWH-031 I see a lot of these LNBs and regularly change older ones because the l.o. has drifted.

[ROMAN42]

If it is a TWF-031 or TWH-031 I see a lot of these LNBs and regularly change older ones because the l.o. has drifted.

TWF-031    just checked on second dual LNB on offset and A/B blindscan find all channels properly       damn 13 years for him is toooo long must order new as long as can buy new and his expensive 60 Euro !!! Ah parabolic 180 cm dish couse only problems Thank guys for your time.

Edited by ROMAN42, 26 June 2018 - 20:17.