6 replies to this topic

[EMMA]

When I load a list and then scan, the results after scanning come up with a low signal so the channels will not work. I tried scanning Bev 91(N.A.) by leaving one channel in list. The channel works before scanning but nothing after cause of low SNR.
What am I doing wrong?

[jonc]

Low SNR =

1. Dish not aligned to the satellite properly - see the wikipedia pages here >>E1Satfind<<
2. LNB setting is wrong (most likely the cause on Bev) see this wikipedia page >> E1Multi <<

[EMMA]

With a downloaded service list for Bev 91, Dish 110and 119 my Dreambox works with Pli.
Its when I try to scan with the NEW Jade that my channels picked up by my scan will not work cause it shows low SNR. The SNR is great before I scan.
I am confused......

[Sicilian]

I think there is a scanning problem with latest update of Jade. Scanning with uk cables.xml. This version scans fine pli-jade-dm500-20080718-5335, latest version scans to a halt after 555mhz.

[EMMA]

I loaded another service list with just one channel from the satellite I wanted to scan and it WORKED!!
I repeated this for Dish 110,119 and Bev 91 and got AWESOME results.
Thanks to all who helped and to Pli Team!!

[chazza]

Hi EMMA, where did you get the service list from?

I know my signal is good enough (for another different receiver), but with new Pli I am getting no lock and low SNR and no services (on 119). I hope it isn't a bad tuner in a clone, but your experience gives me hope.

[hemispherical1]

Chaz, is the lof/h set to 11250 for the NA circular providers (DN/Bev)?



--
hemi